Recently, all available wall plates on MEP content have been equipped with a new functionality. The wall plates have a parameter that regulates the position within the wall. A much heard user wish was to enable this in two directions. It is now possible to place the wall plate not only within the wall, but also with an offset from the wall, with the same parameter. This can be done by using negative values in the parameter.
Wall plates can now be fully adapted to the requirements of your pipeline system. Download generic or SANHA wall plates Revit families and 3D dwg’s from MEPcontent, or directly within a BIM project using the MEPcontent browser for Revit or Autocad.
Wall plates can now be fully adapted to the requirements of your pipeline system. Download generic or SANHA wall plates Revit families and 3D dwg’s from MEPcontent, or directly within a BIM project using the MEPcontent browser for Revit or Autocad.